RAID controller

As RAID controller is responsible for the operations on RAID array drives, it is very important to have an enterprise class controller for enhanced performance, increased reliability and fault tolerance. Considering the business requirement and budget, you can choose a RAID controller. Here I will be explaining about DELL Power Edge RAID Controller (PERC). When choosing a controller, there are few critical hardware features that affect performance to keep in mind :

• Read policy
• Write policy
• Controller cache memory
• CacheCade
• Cut-through I/ O
• FastPath

PERC Series

PERC H810 - high performance RAID controller that can be connected to JBOD

PERC H710P - ideal for implementing hybrid server platforms based on SAS HDDs with high performance and enterprise class reliability

PERC H310 - entry-level RAID controller (no cache)

Reference :
Dell
Microsoft

How to calculate total IOPS supported by a disk array

IOPS stands for input/ output operations per second. 

Consider a RAID array with 4 disks in RAID 5. Each disk is 4TB 15K SAS drive. We can use the below formula for calculating maximum IOPS supported by the RAID array.

Raw IOPS = Disk Speed IOPS * Number of disks

Functional IOPS = (Raw IOPS * Write % / RAID Penalty) + (RAW IOPS * Read %)

No: of disks = 4 (4TB 15K SAS)

IOPS of a single 15K SAS disk = 175 - 210

RAID penalty = 4 (for RAID 5)

Read - Write ratio = 2:1 (say we have 66 % reads and 33 % writes)

From the above details :

Raw IOPS = 175 * 4 = 700

Functional IOPS = (700 * 0.33 / 4) + (700 * 0.66) = 519.75

Therefore, the maximum IOPS supported by this RAID array  = 520

The above calculation is entirely based on assumption that the read - write ration is 2:1. In real time scenarios it may vary depending on the type of workload. That means workload characterization is also important while calculating maximum IOPS value supported by your RAID array. It also depends on the type of RAID, as penalty will be different for different type of RAID. Disk type (SSD, SAS, SATA etc), disk RPM and number of disks also affects the total IOPS value.

From this we can conclude that, if your current IOPS usage is closer to the maximum IOPS supported, then you have to be very cautious as it may lead to I/O contentions due to heavy workloads causing high latency and performance degradation to your storage server.